MANUAL FOR ML7 LATHE No. 720U Ref: 3545 This is a manual for the operation, installation and maintenance of a Myford ML7 lathe, also including tri-leva speed selector. Nov 03, 2017 How do the top 3 rows read, The Metric and BA is clear, but haven't sussed the top three rows. Allan B: 18:32:28: 133 forum posts 23. From serial No. K108718, the cross slides were fitted with self-locking adjusting screws. April 1973 saw the introduction of the new bed. The re-design was necessary to accommodate the power cross feed apron on the Super 7 lathe. At the same time the specification of the ML7 was upgraded to incorporate the 3/4'. When it was unveiled in August, 1946 (at £34, without a motor) the Myford ML7 lathe was greeted with astonishment. Designed by Ted Barrs during the closing years of. Chave De Registro Spyhunter 4 Gratis.

Hi I have a Super 7 fitted with a gearbox which I have owned for about 20 years+ (I have lost the invoice). I had a reason to to determine which model I have and looked for the serial no (on the front lh side of the bed) there is nothing stamped on the bed in that area. I have looked all over the lathe and cannot find one anywhere. What pointers are available to tell me what version of the lathe I have. Thanks in advance Regards Tom Moderator 64 articles Welcome Tom, You should be able to figure it out from here: If you can find the serial number ' While late machines had their serial numbers stamped into the front of the bed, just to the right of the gap, earlier versions in a difficult-to-find location punched into the vertical way on the rear of the bed at its tailstock end' try here: or here: Neil Thank you Neil Found it - Made between 1968 and 1971. Thanks again Regards Tom Please to post a reply.